Based upon your knowledge and experience today, if you were starting all over, what make and model equipment would you go with?
I'm just starting, but here's what I went with:
Forster Co-Ax Press
Forster Micrometer seating dies & FL sizing dies
Forster case trimmer
Redding BR Powder Measure
Redding No. 2 Scales
Cabela's/Berry's tumbler
21st Century Concentricity Gauge and hand-priming tool
I'm not one to go cheap now and upgrade later, it ends up costing more in the long run. I probably spent WAY more than I needed to, especially since I'm just loading hunting rounds for my bolt guns, but I tried to buy what I wouldn't regret.
You have good stuff.
Some of the same list, except I have a Sinclair Concentricity gauge, Lee Classic Cast press and an old Ohaus 1010 scale, my second run of stuff. To do over I wish I'd grabbed a Redding T7 press and a bunch of plates. And I would not part with my RCBS Chargemaster and RCBS Universal Hand Priming Tool. Really like my Forster trimmer and no complaints on the Cabela's/Berry's tumbler.
Still, the most accurate loads I have made were with a wimpy second hand Lee aluminum press, Lee Ram Prime, Lee Collet and Hornady FL and Seating dies, with charges weighed on an old semi-wonky Lyman scale. I think I had stumbled into a few exceptionally accurate factory barrels at the time. LOL. I mainly got into upgrading to the current tools for ease of use and trying to get a handle on runout while troubleshooting while applying what I have learned here on the 'Fire. I really enjoy the micrometer competition seating dies and almost exclusively use Lee Collet neck dies and Redding body when needed. I have zero interest in neck trimming or using bushing dies. I only recently got the Redding powder measure.
The only thing I am currently contemplating is some sort of prep center super multi-tool spinning wonder machine just to be lazy. Someday, the T7 when I get a bigger area to work with, maybe. I used to have a few hundred primers and just a few pounds of powder, now I horde like a fiend!