Good idea on the tool forum. Probably will wind up with metal and wood subdivisions....

It might be helpful to know the dimensions of your slab...

Mills have power planes the ones I have seen will handle up to about a three foot wide plank.

I have seen smaller home shop ones up to about 16" widths.

Once you get into hand tools I think planes are a bit like squares and back saws. You can pay a lot for good stuff and there are only a few places to get them now...I am not sure I would go at a table surface with a little hand plane..

There is part of a wood working reference in the shop. I will see if planing is in it...

-OMotS


"If memory serves fails me..."
Quote: ( unnamed) "been prtty deep in the cooler todaay "

Television and radio are most effective when people question little and think even less.