Originally Posted by HuntnShoot
Originally Posted by Steve Redgwell
Originally Posted by MtnBoomer
Are you referring to the press mounted or bench mounted RCBS swaging tool?

Seen hundreds of posts cussing the press-mounted unit. Had almost purchased such, almost, for a few years before researching. Don't see much negative about the bench tool.



The die mounted swager has to be set up properly for it to work. If the swager goes too deep, it binds. If it doesn't go deep enough, it doesn't fully remove the crimp. I used fired primers to test the primer pockets. It took two or three small adjustments, but it was done. I tightened the lock ring and that was that.

Ocassionally, the swager binds slightly, but a light tap on the press handle frees everything. Mine is set for my Rock Chucker. If you use different presses, pick one and always use that for swaging. It saves messing with the depth adjustment.

[Linked Image from i.imgur.com]

Steve:

You left out Step 2: ream primer pocket with some cutting tool to remove the brass that the swaging tool didn't, in order to be able to seat new primer.


i also have used this tool for years and have never had to use a cutting tool to be able to seat a new primer. the whole premise of swaging is to retain the brass, but move it to a dimension that is able to take the primer. if you are going to use a reamer the swaging is usless.

the consolidation of the states into one vast republic, sure to be aggressive abroad and despotic at home, will be the certain precursor of that ruin which has overwhelmed all those that have preceded. Robert E Lee
~Molɔ̀ːn Labé Skýla~