Home Forums Hunting & Shooting Gunsmithing Boyds Gunstocks

I just received the AT One stock this morning. I needed to fit the trigger guard and forgot about taking the mag from the OEM stock and putting it in the Boyds. So I took it out again and banged the mag into the well. The mag lifts up from the OEM stock. There is a silver clip at the back which secures everything. Just give it a good tug! This is for the Stevens 200/non-accutrigger Savage SA.

It does take some light tapping with a nylon hammer and punch to get it seated. Mine did anyway. I torqued the front screw to 35 in/lb. The rear to 30in/lb. Everything fits and mechanically functions, although the butt pad for LOP was difficult to extend. It's new though, and probably has to be worked a few times. One of these mornings I will get it out to the range.