Yep, pretty basic, just like a guy would figure.

The 24v wire I have been questioning is just outta curiosity. It is landed right where I thought it'd be, on a dry contact.
It's nothing but a relay. The 24v is going into R1 and when the drive starts, the relay closes and it comes out on R10 then heads over to you remote in one of those large gray wires ...but whats it do once it gets there?? inquiring minds wanna know....

D1 is your forward power and D2 is Reverse, DMC is their power source, they will all be landed on the selector switch in the remote.
That's not a drum switch, big difference, the original Mill would have had a drum switch, they have taken it off when they installed the VFD and put in the selector switch.

AI, +10V and ACM are all three connected to your speed control knob aka POT switch (potentiometer).

I'm sure you were just dying to know all of that...lol.
But the guy you have coming over to help you might have a question or two.......

Good Luck!

Padded VA Hospital Rooms for $1000 Alex

Originally Posted by renegade50
My ignoree,s will never be Rock Stars on 24 hr campfire.....Like me!!!!

What are psychotic puppet hunters?