Home Forums Hunting & Shooting Bowhunting Bow tuning "how to"

Ok, finally got around to bare shaft tuning my Invasion to my new arrows.
Since the last part of this guide is tuning for proper arrow flight, i decided to document my starting point, my finishing point, and how I arrived at final results.

This is where we started. Vertical at 90* to target face. Bare shaft tail right. My bow has Bowtechs OD Binary cams with static yokes. Earlier in the thread we discussed setting cam lean at full draw to zero. To adjust the tear we will use the static yoke on the top limb(bottom limb is left alone). Since the nock is tail right, we need to add a twist to the right side and remove a twist from the left side. Continue the process until this result is achieved