Home Forums Hunting & Shooting Ask The Gunwriters Reading Groups

There's a half dozen of these here that get used a lot at my local range....picked them up used for about $8 ea. Since our target frames at 200 are higher than the 100 (you shoot over the top of the 100 yd. target frames), I extended the main tube on 3 of them. For the pivot pin, I used a 1/4-20 coupling nut and drilled out one side of the threads until it fit over the shaft and then JB Welded it on. For the pivot pin, it's just a long 1/4-20 bolt with a non threaded area on the shank. Cut the head off, polish it up and you're good to go. Some I've rounded off and some have been left flat. If the flag is balanced, it doesn't make much difference.