Im working up loads and found a load that measures .89. The problem is all three holes are just touching or very close in a lateral or flat line. Whats the best way to tune this group? If I could just move either outsiide bullets inside my group would be very respectable.
Did you arrive at your group with powder charge only? I don't care for flat lines with powder charge. A flat line is an indicator of a load that is too hot! It might shoot tight sometimes but will be temperamental. Back it down just a touch until you see a triangle group and than seat the bullet deeper in 3 thou increments until it tightens up to all the bullets touching!
I'm assuming you've repeated the group a number of times?
Trystan
