On the Hunter the case rides along the feed lips of the magazine. If you load 3 rounds into the mag it will feed and extract the first two nearly every time but the last round will be dropped. If you pull the bolt out and slide a case into the bolt face the extractor doesn't even touch the brass. Any other of my guns the extractor will grip the case and hold it. That being said when you chamber the round then extract it the case drops out of the extractor and is left sitting there. If another round is in the mag then the round being extracted rides on top of that round and doesn't fall down thus remaining in the extractors grip. Bad thing is that when I got it back from Kimber the note said the extractor was replaced. If it was replaced they never tested the function afterwards. And if it was replaced what else could be wrong? I'm calling Kimber tomorrow and going to try to get them to watch the video. Then it will go back to Kimber again.
