I'll be running a pair of 2 stage compressors with the pressure cut in switches slightly offset so that the come on in stages, primary and backup to double the capacity if needed.

I have a little bit of progress to report.

our foam and pex tubing is done.

[Linked Image]

these rectangular pockets are the thickened areas for my 2 post hoist.

[Linked Image]

[Linked Image]

Far end of this photo you can see where all of the loops come up into what will be my utility room.

[Linked Image]

[Linked Image]

Also my youngest boy helped me assemble these maple butcher block topped benches. Gladiator brand, 25" by 8'. These are actually made in the USA, I like that!

[Linked Image]

[img]http://i43.photobucket.com/albums/e364/northerndave/Mobile%20Uploads/IMG_0400_zps7553c429.jpg[/img]

[img]http://i43.photobucket.com/albums/e364/northerndave/Mobile%20Uploads/IMG_5900_zps9109c000.jpg[/img]

[img]http://i43.photobucket.com/albums/e364/northerndave/Mobile%20Uploads/IMG_3600_zpsdc8bc59a.jpg[/img]



I really like these benches, very well made and very nice looking. My mechanical bench will likely end up getting a stainless cap. This bench will go along a wall next to rollaway toolbox, typical garage bench set up. the second one will hang out from the wall like a walk around bar, I will be able to walk around it, work from both sides for clean work.

Something clever here.