I am about to dip my toes in refinishing a stock. You listed what you used earlier in the thread. Could you go into more detail on the steps please?
Thank you.
Micky
Micky,
I haven't refinished a stock since the 70's. You have to take it down to bare wood. Use wet-and-dry silicon carbide sand paper, the black stuff. I start with 80 grit and end up with 400. Use sanding blocks... many different shapes of sanding blocks so you don't round off sharp edges. Then use as many coats of the McWillaims Alkanet Refinishing Oil as you need to get the desired gloss.
That's the way I would do it now. Be very careful and good luck.
Dick
