That is entirely dependent on the load, but I shot a couple quick groups at 50 yards and they were just above the sheet of typing paper, where normally they are in the middle, so I'd say about 4" high for that case, but I was shooting over the hood of my Land Cruiser. Not exactly formal bench testing. Really its going to depend more on bullet weight.

Very fun little loads, and quite practical in application really.

I have a couple people that have asked me to load for them, so I am going to load up about 500 rds for each of them.

[Linked Image from i.imgur.com]

This time I am going to hold some back for myself, which didn't happen last time I made a bunch of .45s. It was a very accurate .45 load and I ended up getting talked out of my stash, then could not get any more new brass! crazy

I have plenty of ACP brass though.


THE CHAIR IS AGAINST THE WALL.

The Tikka T3 in .308 Winchester is the Glock 19 of the rifle world.

The website is up and running!

www.lostriverammocompany.com