OK, now onto the "squish factor" although I have become better at judging the amount of compound to apply in order to fill the voids in the inletting for a nice mold yet not excessive enough to squish out all over the place when I draw the action in, I still expect to deal with a certain amount of "squish".
Here I have the action drawn down into it's stock with the action screws. I just snug them down, not too tight.
I knew I was going to squish out in the tang area but I'm cool with that. That's what the cotton swabs are for.
Looking up front I was happy to see I had no squish to attend to.
I left the mag box out of the assembly for initial draw down of the action into the stock so I can watch for squish out in the forward area of the mag box inletting. Good thing I did.