We're scaling up a nice looking falling block
to put our 12ga FH big case in.
Here is picture of top part of the
first scale-up model, next to smaller
Wickliffe. It has 12GA FH round in feed
trough. It is aluminum just for a model.
It will handle 12GA FH, 700HE, 700NE, 600NE,
etc. Bottom of block is flat to set on
mill table to do the machining.Next machining
will be the hole and slot down through the
action for breech block and hammer to
slide up and down in.Its taken awhile to
get some tooling.I had none when we set up
vertical mill, and have to get more.The
action model also will be narrowed up when
finished, and contoured to look as good
as the Wickcliffe.Ed.


[Linked Image]

Last edited by hubel458; 12/10/06.
Ed Hubel