I'm using pressure tested, published loads and not exceeding the maximum charge to get the speeds I do.
You want me to post the data from Accurate Powders again?
You know very well they show precisely the results I obtained.
You're the one putting impressionable people in jeopardy not me.
You've declared it perfectly acceptable to exceed max published loads for the 7RM if "you've been doing it a long time."
Still, as you said, you don't know what pressures you're running either. At least I stop when I hit the max load. That's a whole lot better guarantor of being within safe pressure limits than blowing right by max loads and going by "pressure signs".
Not really into this squabble, I'll keep my standard 280
But I'm curious, you seem to be quite happy to frown on people that perhaps would exceed published data yet in another quote, you freely acknowledge that same data has been been reduced over the yrs likely because of liability. Do you now consider that old data unsafe?
"
Don't be disingenuous Bob. You and I both know that SAAMI has reduced the MAP of the 7RM at least once and probably twice since it's intro."
