You guys are just too clever! -laffin'-

It wasn't quite straight up, I had to use my track shoes to get under it for the score.

OK, I give up. Tubing cutter, blade at mid point in the case and very gradual increase of cutting pressure. Turn a couple times, tweak the knob etc. NOT that knob....

After about 3-4 minutes the case broke in half and I began phase 2. Dumped the powder, picked up the small wire cutters, aka dykes and split the case up to about 1/16' shy of the bullet base. Peeled the two lobes back and pulled out the hacksaw. Couple or 12 back strokes to score the side of the case, 2 pair of needle nose pliers and the case mouth split as I rolled them apart. Bullet dropped out with a very minor nick on one side of the heel from the saw. 39.6 grains. .208" diameter on the heel, that being about .110" long.

Redneck engineering rocks...........

I am..........disturbed.

Concerning the difference between man and the jackass: some observers hold that there isn't any. But this wrongs the jackass. -Twain